Influence Of Plate Making Process

Resin needs to be exposed in the sedan and drying, drying time determines how much moisture. Relative water content of the water slightly less long, sometimes when I started printing die-cut and die-cutting knife is good, changed after the long version of the problem, can be solved by way of baking again.

Printing pressure

In the printing process if the pressure is too high causing the resin to be squeezed, causes between die-cut and print sets are not allowed. Notably softer materials this phenomenon more commonly seen.

Above and round knife sets are not allowed in the relatively high precision die-cutting requirements of electronic labels more clear. Some label the 5-8 mould only 0.2-0.3mm of tolerance, usually require very high precision die-cutting label is not obvious.